MultiStar ESCs are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If you're starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.

These V2 ESC's features BLHeli software for a very smooth yet linear throttle response, without sacrificing a rapid, crisp, response to any throttle input.

The nano 6A comes with easy to solder power and motor tabs for a tidy and light install, and comes with 2mm bullet connector and wires for use as well.

All Multistar ESC's feature an ATmega MCU that opens the door to customizable firmware – The V2 Multistar comes with BLheli software pre-installed, and for those so inclined a ease to use USB tool is available for Configuration and updating via the BLHeli Suite GUI.

Please refer to the related items below for a solder free multi-rotor power solution to suit your next multi-rotor project.

Features:
• BLHeli Software
• USB tool updating and configuration via BLHeli GUI software
• Smooth and linear throttle control
• Fast response to throttle input
• Atmel MCU
• Stalled motor protection
• Throttle signal lose protection
• Safe power-on (throttle lockout)
• Support 480Hz+ high refresh rates (up to 499hz)
• Supports Oneshot125

Specs:
Constant Current: 6A
Input Voltage: 2-3 cell Lipoly
BEC Output: N/A OPTO
PWM: 8 KHz
Max RPM: 240,000rpm for 2 Pole Brushless Motor
PCB Size: 21mm x 11mm
Discharge Plugs: Solder pads
Motor Plugs: Solder pads
Weight: 2g