Running-in Fix the engine on the model and run it at low rpm for at least 30 minutes.
Start Put the model on the starting box connect the glowplug to the specific device connected with a battery of 1.5-2.0 volt.
Blow Out Stop the engine by closing the needle valve through the remote radio control or use a rag to cover the exhaust tip. Be careful! The exhaust is extremely hot. So you must use a thicker rag.
Fuel Using a good quality fuel to avoid rust and oxidation occurred in engine. Good fuel is composed of alcohol without water, good nitro and ungummed oil.
Air filter You should carefully maintain the air filter to avoid dust and sand go into engine.
Wisely Control Accelerating the engine, let the pipe noise as quiet as possible to avoid skidding to the model. Sharp acceleration causes the balls of bearing skidding against their sliding guide and consequent wear.
|